mTAP Lite has 3 major components that need to work together to make the device work.
These are :
- MagTek DynaFlex2Go EMV card reader
- mHub - Mini Smartphone which runs the mHub App
- Battery pack/Wired Power hub to provide charge to the mHub and card readers
mHub should be configured first to ensure the proper functioning of the mTAP device.
Follow the 4 steps outlined below in the same order to ensure the proper configuration and setup of mTAP.
Step 1: mHub Configuration
mTAP hub should be configured first before mounting the final hardware assembly. The following procedure is recommended to be followed as the first step of setting up mTAP.
Step 2: Connect Readers
Follow the instructions below to connect the card reader with the mHub .
Step 3: mTAP Lite hardware assembly
Once the reader is connected with the mHub device follow below instructions to finish setting up the mTAP Lite hardware.
Step 4: Setup receipts
Follow the link below to configure MOHID to generaate receipts for the mTAP transactions
How to enable Checkout Mode
Checkout mode is a special feature which is only available for mTAP Lite devices. Follow the link below to enable this feature if needed.