Knowledge Base

1. Place the Floor Plate (C) upside down on a flat surface
   

   
   

1. Connect the Floor Plate (C) with the Bottom Stem (A) usng the Hex Nut (D) and the Washer(E)
   
2. Hand tighten the Hex Nut (D) through the Washer (E) first and then use the Allen Key (F) to tighten the Hex Nut to the Floor Plate (C)
   

   
   
3. Now flip the stand so that the Floor Plate(C) is flat on the floor
   
   
4. Insert the Top Stem (B) into the Bottom Stem (A) and Tigthen the Black Thumb screw at the Right side of the Bottom Stem to hold the Top Stem at a high position. (Leave a gap of atleast 18 inches between Top Stem and the Bottom Stem)
   

   
   

   
   

   
   

   
   
5. Place the mTAP Frame between the Top Stem slot and the bottom Stem slot, as shown in the picture below. Make sure the charging cables are routed above the Top Stem (See the picture below)
   
   
6. Loosen the Black thumb screw on the Bottom Stem and carefully slide the Top Stem down so that it will catch the Top edge of the mTAP frame securely.
   
   Caution: The Top Stem is very heavy, so it will free fall on the mTAP Frame if you let it go down, be careful when slidding the Top Stem down.

mTAP Frame Hardware setup is now Completed.