IMPORTANT: MTAP Hub should be running version 3.5 or higher to use this method.
Use this method to connect your mTAP Hub to available WiFi networks without entering the password in your hub screen.
Step 1:
- Power on your mTAP Hub and wait till you see the QR code login screen
- Tap on the WiFi icon at the top of the screen, as shown in the picture
- Make sure that the WiFi is enabled.
- If WiFi is not enabled, tap the switch to enable WiFi
- Tap Done and close the pop-up (Do not select any WiFi network at this stage)
Step 2:
- Tap the QR code icon next to the WiFi icon on the top
- This will open WiFi Setup screen on the mTAP hub with a QR code shown like in the below picture
- Follow the instructions in the screen.
- Open the camera app on your Android or iPhone and scan the big QR code visible on the WiFi Setup screen
- Once the QR code is scanned, tap on the message which says AndroidShare_9521
- The phone will get connected to a temporary Local WiFi network
Step 3:
- Now scroll down on the mTAP hub WiFi setup screen to show the small QR code
- Open the camera App on your phone again and scan the small QR code on mTAP hub WiFi Setup screen
- Tap on the IP Address message displayed on your phone.
- Your phone will open a browser page and show available WiFi Networks around the mTAP Hub.
- Select the network to connect , enetr password and tap Send to Kiosk
- Following message will be displayed on the mTAP hub screen, tap Connect and Allow
- Tap Done and your mTAP Hub will be connected to WiFi !
